General Purpose Input and Output and Peripheral Bridging

The XVF3610 supports I/O expansion and protocol bridging over USB and I2C for the XVF3610-UA and XVF3610-INT respectively. This allows peripheral devices such as audio hardware connected to XVF3610 to be configured and monitored by the host.

../../../_images/image12.png

Fig. 30 Device GPIO interfaces

  • Four GPI channels (pins)

  • Direct read of port value

  • Rising, falling or both edge capture with “sticky” bit which is cleared on read

  • Mode configurable per pin

  • Four GPO channels (pins)

  • Direct write of entire port or pin

  • Active high or Active low

  • 500Hz PWM configurable between 0 and 100% duty cycle

  • Blinking control supporting a sequence of 32, 100ms states

  • SPI Master

  • 1Mbps SPI clock

  • Up to 128 Bytes SPI write

  • Up to 56 Bytes SPI read

  • I2C Master (XVF3610-UA only)

  • 100kbps SCL clock speed

  • Register read/write (byte)

  • Up to 56 byte I2C read/write

The following sections describe the configuration and usage of each peripheral interface.