UART Tx RTOS Driver

This driver can be used to instantiate and control an UART Tx I/O interface on xCORE in an RTOS application.

UART Tx API

The following structures and functions are used to initialize and start a UART Tx driver instance.

typedef struct rtos_uart_tx_struct rtos_uart_tx_t

Typedef to the RTOS UART tx driver instance struct.

inline void rtos_uart_tx_write(rtos_uart_tx_t *ctx, const uint8_t buf[], size_t n)

Writes data to an initialized and started UART instance. Unlike the UART rx, an xcore logical core is not reserved. The UART transmission is a function call and the the function blocks until the stop bit of the last byte to be transmittted has completed. Interrupts are masked during this time to avoid stretching of the waveform. Consequently, the tx consumes cycles from the caller thread.

Parameters

  • ctx – A pointer to the UART Tx driver instance to use.

  • buf – The buffer containing data to write.

  • n – The number of bytes to write.

void rtos_uart_tx_init(rtos_uart_tx_t *ctx, const port_t tx_port, const uint32_t baud_rate, const uint8_t num_data_bits, const uart_parity_t parity, const uint8_t stop_bits, hwtimer_t tmr)

Initialises an RTOS UART tx driver instance. This must only be called by the tile that owns the driver instance. It may be called either before or after starting the RTOS, but must be called before calling rtos_uart_tx_start() or any of the core UART tx driver functions with this instance.

Parameters

  • ctx – A pointer to the UART tx driver instance to initialise.

  • tx_port – The port containing the transmit pin

  • baud_rate – The baud rate of the UART in bits per second.

  • num_data_bits – The number of data bits per frame sent.

  • parity – The type of parity used. See uart_parity_t above.

  • stop_bits – The number of stop bits asserted at the of the frame.

  • tmr – The resource id of the timer to be used by the UART tx.

void rtos_uart_tx_start(rtos_uart_tx_t *ctx)

Starts an RTOS UART tx driver instance. This must only be called by the tile that owns the driver instance. It may be called either before or after starting the RTOS, but must be called before any of the core UART tx driver functions are called with this instance.

rtos_uart_tx_init() must be called on this UART tx driver instance prior to calling this.

Parameters

ctx – A pointer to the UART tx driver instance to start.

struct rtos_uart_tx_struct
#include <rtos_uart_tx.h>

Struct representing an RTOS UART tx driver instance.

The members in this struct should not be accessed directly.

UART Tx RPC Initialization API

The following functions may be used to share a UART Tx driver instance with other xCORE tiles. Tiles that the driver instance is shared with may call any of the core functions listed above.

Warning

doxygengroup: Cannot find group “rtos_uart_tx_driver_rpc” in doxygen xml output for project “XCORE Software Development Kit” from directory: /build/doc/_build/_doxygen/xml/