RTOS Driver Tests¶
The RTOS driver tests are designed to regression test RTOS driver behavior for the following drivers:
gpio
i2c
i2s
intertile
mic_array
qspi_flash
swmem
These tests assume that the associated RTOS and HILs used have been verified by their own localized separate testing.
These tests should be run whenever the code or submodules in modules\rtos or modules\hil are changed.
Hardware Setup¶
The target hardware for these tests is the XCORE-AI-EXPLORER board.
To setup the board for testing, the following connections must be made:
Pin Desc hil |
Pin Desc hil_add |
Connection |
Port Name |
|---|---|---|---|
GPIO I/O |
Unused |
X1D02 : X1D39 |
T1 XS1_PORT_4A Pin 0 : T1 XS1_PORT_1P |
I2C SCL |
UART TX/RX |
SCL IOL : X1D36 |
T0 XS1_PORT_1N : T1 XS1_PORT_1M |
I2C SDA |
SPI CS |
SDA IOL : X1D38 |
T0 XS1_PORT_1O : T1 XS1_PORT_1O |
I2S DACD |
SPI MOSI |
DAC_DAT : X0D12 |
T1 XS1_PORT_1A : T0 XS1_PORT_1E |
I2S ADCD |
SPI MISO |
ADC_DAT : X0D13 |
T1 XS1_PORT_1N : T0 XS1_PORT_1F |
I2S BCLK |
Unused |
BCLK : X0D22 |
T1 XS1_PORT_1C : T0 XS1_PORT_1G |
I2S LRCLK |
SPI SCLK |
LRCLK : X0D23 |
T1 XS1_PORT_1B : T0 XS1_PORT_1H |
Wiring Diagram¶
